Best Tool For Removing Carpet Tack Strips

If you are pulling up carpet from stairs.

Best tool for removing carpet tack strips.

Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced. Roll or fold the strip secure with duct tape and remove it from the room. Press the pry bar in order to begin lifting the tack strip. Then tap it with a hammer until the tack strip pops up.

You should also remove the tack strip if it s less than 1 4 in. Wide to tuck the edge of the carpet down against the baseboard. At those points slide a pry bar under the tack strip. To remove tack strip just pop it up with a flat pry bar.

Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. Begin at the top of the stairs. Pick somewhere to start either a corner or a break between two tack strips. Carpet tack strips can usually remain in place but look for rust rot or other damage.

Reinsert them beside the next nail on the tack strip and pop that nail out the same way. The installer needs a gap at least 1 4 in. Some people have a hard time with this step but i ll show you how to remove carpet tack strips the easy way with three simple tools. Pull the pry bar free and remove the putty knife if you re using one.

Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. Rust can bleed through the carpet creating stains on the surface.